Dashboard - update 1 pod

[JeffKimmel]

All,

I have the enclosed dashboard. I have a timer that fires off to check to see if there are new messages. When a driver has a new message it highlights like shown on the second report. When I click the link, it refreshes the report by calling the selnext(). This works OK but it refreshes all the pods & I would like it to only refresh the one report. Is there a way to do that?

Thanks,

Jeff

[Carsten Sørensen]

Hi Jeff,

If you try setting the refresh interval on the individual report in the package -you might be able to just call the refresh function for the list.

Best regards,
Carsten

[JeffKimmel]

Carsten,

Thanks for the advice. I think there's a problem with the refresh interval bit. When I set it, it re-runs all the reports as expected but it sets all the reports to the same driver. See the enclosed file for what I'm talking about. I'm using the multi-run report trick. I'm also assuming you are talking about the following functions for the refresh:

ACallfl15480111585486();
ACallfl25480111585486();


Will these name ever change & if so, is there a way I can tell what they are in the javascript code? And to kind of re-state the problem above, when I call these functions it refreshes the expected report but it uses the wrong driver.

Thanks,

Jeff

[Carsten Sørensen]

Hi Jeff,

I wasn't aware of the use of multi-run. You are right that the ACall.... function would not take the multi-run into account. Multi-run originated in creating a package of reports for n number of customers / companies etc. especially for print-reports - and therefore it hasn't been used previously for individual report refreshes. I think unfortunately that if you need refresh on a multi-run the only real option is "selnext" which you already used initially with the disadvantage that everything refreshes...

Best regards,
Carsten

[JeffKimmel]

Carsten,

Thanks for the reply. I'll try to tackle this a different way.

Jeff