Dynamic AI Support Forum

All,

I have the enclosed dashboard. I have a timer that fires off to check to see if there are new messages. When a driver has a new message it highlights like shown on the second report. When I click the link, it refreshes the report by calling the selnext(). This works OK but it refreshes all the pods & I would like it to only refresh the one report. Is there a way to do that?

Thanks,

Jeff

Hi Jeff,

If you try setting the refresh interval on the individual report in the package -you might be able to just call the refresh function for the list.

Best regards,
Carsten

Carsten,

Thanks for the advice. I think there's a problem with the refresh interval bit. When I set it, it re-runs all the reports as expected but it sets all the reports to the same driver. See the enclosed file for what I'm talking about. I'm using the multi-run report trick. I'm also assuming you are talking about the following functions for the refresh:

ACallfl15480111585486();
ACallfl25480111585486();


Will these name ever change & if so, is there a way I can tell what they are in the javascript code? And to kind of re-state the problem above, when I call these functions it refreshes the expected report but it uses the wrong driver.

Thanks,

Jeff

Hi Jeff,

I wasn't aware of the use of multi-run. You are right that the ACall.... function would not take the multi-run into account. Multi-run originated in creating a package of reports for n number of customers / companies etc. especially for print-reports - and therefore it hasn't been used previously for individual report refreshes. I think unfortunately that if you need refresh on a multi-run the only real option is "selnext" which you already used initially with the disadvantage that everything refreshes...

Best regards,
Carsten

Carsten,

Thanks for the reply. I'll try to tackle this a different way.

Jeff